[BC] Trilithic EASyCast Configuration

[Robert Meuser]

The solution is easy. Download the .net from the Microsoft website or 
Google ,net 4.0 there are many places where it can be found.  Get a 
cross over cable so the computer and the Easycast can connect directly 
to each other. Hopefully you know the value of the third octet of the 
10.1 IP if that is the case, just assign and arbitrary 10.1 address to 
the computer temporarily.

If the network has very basic equipment, just plug in the Easycast and 
change the computer IP. It will work despite the address being wrong. 
BTW using an IP like 192.168.xx.xx is not the best practice. It is 
better to use 10.xx.xx.xx

On 6/29/12 12:31 PM, rbshreve at cape-may.net wrote:
>
> 1.      The software disk for the EASyCap had damaged files for the
> necessary .NET 4.0 installation.
>
> 2.      The off-the-shelf hardware ships with a static IP in the 10.1.xx.xx
> subnet which is not compatible with our 192.168.1.xx LAN.   Even though
> connected via RS232 comm port, the Trilithic configuration software does not
> install the proper static IP in the EASyCast.  You must do this by changing
> the properties of your computer temporarily to give it access to the
> 10.1.xx.xx subnet, connect to the NIC's static IP (listed in the
> configuration file it you display it), and then the Trilithic EASyCast
> software will change the static IP successfully.
>