[BC] Starlink Interleaver adjustment

[Rick Levy]

>>
Has anyone tried, and noticed significant reliability improvement from,
increasing the interleaver settings in the Moseley Starlink STL (16QAM)
from the default of 3 to the max of 12?

I need to do whatever I can to overcome occasional very brief ducting
dropouts and BER glitches in a 30 mile over swamp path.

Delay is not a concern, BER is.
<<

Made that very change recently, with immediate benefits.  The number of 
uncorrected errors ("Post" correction) went from the 1 in 40 range to 
something like 1 in 300, typically.  These figures vary a lot with severity 
of the interference.  Situation is a little different - problem is 
interference (of unknown origin, but must be broadband or co-channel because 
receiver is fitted with a narrow bandpass filter) rather than ducting 
dropouts; a short urban path in an rf-noisy environment; 32QAM system.  If 
the (14?) extra milliseconds of delay don't matter, I can't think of any 
reason not to set the interleaver to the max. of "12" and leave it there. 
Go for it.