[BC] Assistance with BE AM-1A
Mark Earle
mearle at mearle.com
Sat Nov 27 07:50:22 CST 2010
On 11/26/2010 11:15 PM, Henry Royce wrote:
> Requesting help from the school of experience.... I have read the manual and called Quincy but I am not getting much help on a problems with my BE AM1A.
>
Others have made suggestions. I *think* there is a battery somewhere to
change. Like you, the one I work on just goes.
One problem (Barry has this in the BDR somewhere). If you've not done
this, shut down, CAREFULLY remove the factory metal air filters, get
some non-metal ones of same size, Vacuum out all the pieces of metal
that have come off the filters and got in to the transmitter.
Been a while since I've done that but "some"' of the factory filters
"shed" metal pieces.
ON the one maintain, the remote control works, as do the front panel
buttons.
> 1.Can't trim power using front panel push buttons.(although it
> works fine on remote control)
> 2.Can't switch between + and - modulation on the front panel
> modulation meter.
> 3.Am not sure we are reaching +125% positive peaks.(Since I can't
> switch the mod. meter on the front panel)
>
> This is the downside of having a transmitter that just runs with few problems. One never 'enters into a relationship' with this thing! Any suggestions would be most welcome
>
> Henry Royse
> WCLU Glasgow, KY
>
> ________________________________________________________________
>
--
mwe
) )
) ) You will be assimilated... oooh, coffee!!
( | |
More information about the Broadcast
mailing list