[BC] Gates Yard schematic or manual
Phil Alexander
dynotherm
Tue Oct 25 00:51:41 CDT 2005
On 24 Oct 2005 at 23:18, DHultsman5 at aol.com wrote:
>
> In a message dated 10/24/2005 10:34:55 AM Central Standard Time,
> charlesr at infonline.net writes:
>
> There are differences in the muting relay connections. iirc the Yard
> uses independent muting relay coils and the Gatesway/Dualux put the
> relay coils in series.
>
>
>
> In the case of the Dualux, the relays got their DC supply from the center
> tap of the DC return on the full wave rectifier supply. The relays were made
> by running the DC in series with each relay to ground. When you turned on
> the microphone the mike switch contacts shorted around the relay coil DC,
> allowing the relay to drop instead of "pulling in", muting the speaker and turn on
> the on air lights. When you turned off the AC to the power supply the on
> air lights outside the control rooms and studios would all say "On The Air".
>
UNLESS ... you fed the supply terminals for the lights from the same circuit
you used to feed the PS/mon/mute module. <g>
The really cute part about this way you could mount that chassis in the CR
and not hear the clicks on air via the CR mike because the relays made almost
no noise when they dropped out, unlike when pulling in.
Phil Alexander, CSRE, AMD
Broadcast Engineering Services and Technology
(a Div. of Advanced Parts Corporation)
Ph. (317) 335-2065 FAX (317) 335-9037
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.361 / Virus Database: 267.12.4/146 - Release Date: 10/21/05
More information about the Broadcast
mailing list