[EAS] Main Studio Question

[Mike McCarthy]

My prior comments not withstanding, I have multiple stations configured
this way and the way Larry Wood described.

What makes my installation challenging is I have a building top 6KW TX
40KHz offset from the LP2 and 100Khz from the LP-1. And even despite both
LP-1 and LP-2 having 100+mV signals at the studio site, the local TX
emission compresses the RX's so badly the signal is not recoverable.

So I have a single receiver system (Innovonics INomni RX's) a couple
blocks distant which then service 5 stations worth of EAS boxes both in
that studio, a remote TX site, and the 2nd set of studios.  All fed by
varying combinations of Intraplex cards.

Simple doesn't always lend itself to our business...

MM

On Thu, February 1, 2018 10:58 am, Richard Rudman wrote:
> You put the EAS equipment and the off Air receivers at the transmitter
> site. I have five installations where it is much more practical to do
> this rather than back haul audio to the program source. You then have to
> contract with an ISP for Internet if there is none there for IPAWS
> polling.
>