[EAS] Two Primary areas?

[Lowell Kiesow]

Ed,

The Sage can easily be set to use different location codes for the 
RMT than for other event codes.  I am not familiar with any other 
product that can do that.  Scanning multiple CAP servers is no 
problem for Sage either.

If you want the alert filters for the two stations to be different, 
then you really should use one Sage for each station.

At 11:59 AM 7/15/2011, you wrote:

>I remain confused on how to handle the following with CAP and CAP 
>compliant new EAS units.
>
>One client has two stations, both in the same building and 
>monitoring the same area, with individual SAGE units that share 
>common receivers.  One station however monitors counties in two 
>states.  Currently in their SAGE unit I have counties of both states 
>listed as their local area.  Two receivers monitor the stations 
>required of their 'home' state plan and the fourth receiver monitors 
>one county across the river so to speak.  The system responds well 
>to both states, although ideally I would prefer to not respond to 
>the RMT of the second state.  This dual monitoring is done at the 
>request of the coordinator in the adjacent state, because that 
>area's local station is notoriously lacking in compliance.
>

         Lowell Kiesow, Chief Engineer
         KPLU 88.5, KVIX 89.3, KPLI 90.1
         www.kplu.org www.jazz24.org