[BC] Symetrix AirTools delay PSU

[Mike McCarthy]

Tim,

Have you considered simply re-capping the power supplies?  Is it 
possible?  I've not needed to get into one yet.

Are there any OEM markings on the power supply?  Many of these so called 
unobtainium supplies have been merely replaced by an identical to the 
old device except for a changed part or two. Or were simply bought by 
someone and the name changed. They're otherwise direct replacements.

When you have a solution or a parts list, please advise as I have 5 of 
them in operation and would prefer to avoid reinventing the wheel if at 
all possible.

MM

On 11/2/2013 11:50 PM, Tim Backer wrote:
> Hi all!
>
> I've got a bunch of AirTools 6000/6100 delays in service, and I'm starting
> to have power supply failures.  Symetrix says that they're unobtanium for
> the most part, and I can't seem to find something to fit on the net.  I
> could drill & blast to fit something else in there, but I neither have the