[BC] BE AM 2.5 stereo problem

[Andy Linton]

Hey all, our BE AM2.5, which we run in stereo, has a problem in that there is very little separation.

If I disconnect audio from either audio input, the resulting 'dead' channel then shows audio only abt 6dB down from the other, 'live' channel. Happens both ways around.

Looking at the alignment procedure, with tone into either channel I see a slightly distorted elliptical Lissajous figure - again the same for L and R. Adjusting the delay jumpers or multiturn pot has no effect at all.

Does anyone please have any experience with the CQUAM setup of this tx, and can offer advice please?

The tx was working fine when last used a year ago.

------------------------

Andy Linton
Kilkenny, Ireland.