[BC] XDS Programming

[Tom]

Hmmm

This is a

Good Idea®

Should work for ANY size DB-x connector...

Thanks, Jerry!

Jerry Mathis wrote:
snip
> I made a little jig using one hood, I carved away the shell back to the wire
> clamp using a Dremel tool, and fastened it to a board. I put the two end
> bolts into the assembly and got two nuts from an old computer card. Now I
> put my 37-pin solder connector into the jig, lay my cable into the shell and
> clamp it, then position each wire pair over to where it will solder to the
> connector. Cut the wires to length, strip the ends, and you can solder the
> wires neatly into the connector. You have to do one row at a time, then turn
> the connector over and do the other side. Use a low-wattage soldering iron
> with a small conical tip, and you can do a professional-looking job.

-- 
Tom Spencer
PG-18-25453 (nee' P1-18-48841)
http://radioxtz.com/