[BC] Harris SX-1A NRSC woes...

[Alan Alsobrook]

There is one of those "Buss bar" fuses on the Right side wall about 1' 
up from the floor that I had blow. It was in the ground return for the 
PA section. I determined that the blow was caused by a B+ wire laying 
against it and slowly melting into it over the years. Since finding that 
I've check a couple more and found the same problem that hadn't turned 
into a boom yet!

Milton R. Holladay Jr. wrote:
> I was just working on an early SX-1A that suddenly had a case of the
> can't-help-its ( no output, 64% drive, pinned voltage meter, &c.) After
> shutdown, when powered back up it blew the big fuse that's sorta hidden down
> in the corner and the TIP125 on the AC controller 

-- 
Alan Alsobrook CSRE AMD CBNT
St. Augustine Fl. 32086 904-829-8885
aalso at Bellsouth.net