[BC] Networking question:

[Jeff Johnson]

I've run into this when Ethernet 'duplex' mode and/ or link speed does not 
match. This is set under 'link speed and duplex mode' in the 
properties/advanced tab of the NIC's entry in Device Manager. Set to 
'Automatic'.

Jeff.Johnson at rfproof.com, CSRE
RFPROOF.COM

>On Friday 04 April 2008 02:04 pm, Glen Kippel wrote:
> >  OK, Brainy People -- I have a problem.  One of our audio recording/editing
> >  computers went up in smoke and I moved the hard drive and sound card 
> over to
> >  another computer.  Everything looked good on the workbench; I could 
> connect
> >  to the internet, etc.  But when I put it back in the control room it won't
> >  connect to the network.  No servers, no internet, nothing.  All I get is
> >  "Limited or no connectability."   The router shows a light when it is
> >  plugged in, and it goes out when I unplug the cable.  Running Network 
> Setup
> >  Wizard doesn't get me anywhere.  It's like it's giving me the wrong IP
> >  address.  What am I doing wrong here?  Any input would be appreciated.
> >  Thank you.