[BC] Starguide Channel Swap

[Scott]

I don't know if this will help but if you go to the bottom of page 25 and 
the top of page 26 in the Starguide Manual at this URL
http://www.gcnlive.com/SGIIImanual.pdf
it says that you can swap Left and Right in the software.

This is what the manual says for that section if you can't access the site
5.2 Audio Mode - AM

The AM command changes the audio output on a port-by-port basis. This 
command does NOT

work if the TZF mode is set to any non-zero value since the TZF and the AM 
commands

manipulate the same copy/swap bits in the audio decoder.

The audio mode command comes in the following formats:

AM port This form of the command queries the audio mode set for the

specified port.

Port valid values range from "A" to "F"

AM port,mode This form of the command sets the audio mode on a specific port

to the specified value. If the TZF value is non-zero then this

command will not be executed and a "Not Available" response will

be issued.

Port: valid values range from "A" to "F"

Mode: valid values range from "0" to "3"

The following shows the definitions of each of the audio modes:

26 StarGuide Digital Networks

0: Normal

1: Copy left channel to right channel

2: Copy right channel to left channel

3: Swap left and right channels

The AM settings are saved in non-volatile memory

Good Luck
Scott O. Luse
----- Original Message ----- 
From: "Don Niccum" <donn at dfn.com>
To: <broadcast at radiolists.net>; <radio-tech at broadcast.net>
Sent: Wednesday, October 17, 2007 1:00 PM
Subject: [BC] Starguide Channel Swap


>I do not have access to a Starguide 3 manual.
> Does anyone know the procedure for swappping channels?
> i.e. making left right and right left.
>
> Thanks!
> Don Niccum
> Roswell, NM
> donn at dfn.com
>
>
>
> ___________________________________________________________
> Sent via DFN Systems Web Mail at dfn.com
>
>
>
>
> _______________________________________________
>
> The BROADCAST [BC] list is sponsored by SystemsStore On-Line Sales
> Cable-Connectors-Blocks-Racks-Test Gear-Tools-Lots More + Now Barix too!
> www.SystemsStore.com       Tel: 407-656-3719    Sales at SystemsStore.com
>
>
>
>