[BC] Are they all this way? (crunchy Compellor)

[Dana Puopolo]

I used to completely bypass the output stage and pull the output from the
stage before it. Turns out it also was a balanced differential output-just not
a crosscoupled one.

-D

------ Original Message ------
Received: Thu, 11 Oct 2007 08:37:32 AM EDT
From: "gRAdy Moates" <lists at loudandclean.com>

     Every Compellor 300 with which I've worked has had a problem,
however. . . if not loaded with a fairly low load impedance, my units
all exhibited a cross-over distortion "glitch" that was quite audible,
and gave the units a "crunchy" sound.  Placing a 1K-ohm-or-so
load resistor across the outputs (between pins 2 and 3) cleaned
up the sound on my units quite dramatically.