[BC] Assistance With A PI Network Calculation

[Harold Hallikainen]

Though I haven't worked it out, I THINK a pi network is similar to a 90
degree T network. For the T network, each component has the same reactance
as the "characteristic impedance" of the network. And when using a 90
degree network to transform impedance, the characteristic impedance of the
network should be the geometric mean of the source and load impedances
(square root of the product of the two impedances). See
http://sujan.hallikainen.org/rw/theory/theory13.html .

Again, just thinking about it, I THINK a pi would behave similarly to an
L. The math is left as an exercise for the student.

Harold


> I was going through my junk box trying to determine what kind
> of AM transmitter I might be able to build with available
> parts.  I came up with enough parts for a final power
> amplifier using three 1625s (12 volt version of the 807) in
> parallel.  Wonder if someone could give me the approximate
> values of the input and output capacitors for the PI network
> at 3.8 MHz?
>
> The 1625s will have about 700 volts on the plates with 300 MA
> which is a plate load of 2333 ohms.  The output of the PI
> network will of course feed 50 ohms.
>
> Thanks,
>
> Tom
>
>
> _______________________________________________
>
> The BROADCAST [BC] list is sponsored by SystemsStore On-Line Sales
> Cable-Connectors-Blocks-Racks-Wire Management-Test Gear-Tools and More!
> www.SystemsStore.com       Tel: 407-656-3719    Sales at SystemsStore.com
>
>


-- 
FCC Rules Updated Daily at http://www.hallikainen.com - Advertising
opportunities available!