[BC] New respect for tower climbers!
Dana Puopolo
dpuopolo
Fri Apr 27 20:13:02 CDT 2007
Hmmmm..
What did I do to piss him off?
-D
------ Original Message ------
Received: Fri, 27 Apr 2007 08:16:27 PM EDT
From: dtcasey at comcast.net
To: "Broadcasters' Mailing List" <broadcast at radiolists.net>
Subject: Re: [BC] New respect for tower climbers!
Can you please remove me from your e-mail group. thanks
-------------- Original message --------------
From: "Dana Puopolo" <dpuopolo at usa.net>
> Mitered 90 degree elbows historically give more problems then any other type
> of transmission line part COMBINED! I remember one installation where an 3
> inch FM transmssion line had to go around/over two bays of a TV batwing aux.
> antenna. The whole thing was done with 90 deg miters and they blew an
average
> of one out per year. I suggested they replace the whole top with a 30 foot
> piece on 2 1/4 line (which could bend around each TV bay), as the line
> length/loss of the 3 inch line was such that by the time you got to the top
of
> the tower, the power had dropped down into the safety range of the 21/4. I
> don't know if they ever did this though...(it's now a CC station).
>
> -D
>
> ------ Original Message ------
> Received:
> From: Tom Bosscher
> To: "Broadcasters' Mailing List"
> Subject: Re: [BC] New respect for tower climbers!
>
> I DVR'd the 12 mid feed. The problem was at the top of the tower, a
> 3" 90 degree elbow has developed a leak along the weld seam. They were
> going to do a simple glue/tape repair. I would have wanted to replace
> the elbow. And when they put the glue on. the line was still
> pressurized, which caused a delay of time problem. . I even mentioned to
> my wife, when they started the climb, that I hope they opened the purge
> valve at the bottom, so there was no pressure.. But they didn't. Too bad
> they didn't have a 5 second B roll of the transmitter room. We all know
> that is what "we" here wanted to see!
>
> Nice looking FM DA array. There were the typical media type reporting
> errors, but overall it was not bad.
>
> tom bosscher
>
>
> _______________________________________________
>
> The BROADCAST [BC] list is sponsored by SystemsStore On-Line Sales
> Cable-Connectors-Blocks-Racks-Wire Management-Test Gear-Tools and More!
> www.SystemsStore.com Tel: 407-656-3719 Sales at SystemsStore.com
>
>
>
>
>
> _______________________________________________
>
> The BROADCAST [BC] list is sponsored by SystemsStore On-Line Sales
> Cable-Connectors-Blocks-Racks-Wire Management-Test Gear-Tools and More!
> www.SystemsStore.com Tel: 407-656-3719 Sales at SystemsStore.com
>
_______________________________________________
The BROADCAST [BC] list is sponsored by SystemsStore On-Line Sales
Cable-Connectors-Blocks-Racks-Wire Management-Test Gear-Tools and More!
www.SystemsStore.com Tel: 407-656-3719 Sales at SystemsStore.com
More information about the Broadcast
mailing list