[BC] EAS Logs

[Glen Kippel]

Bill is correct.  It may be considered prudent to unplug the device 
from AC first.  It can be a bit of a bear to reload the paper.  I 
would cut the end of the paper in a "V" shape and then cut the very 
end off a bit to make it easier to feed the paper in.  Plug the EAS 
back in to the AC line, and push down the two buttons to start the 
printer feed.  After you get the paper through the printer, slide the 
printer back into the box.

On 4/16/07, Bill Croghan 
<<mailto:loteng at lvradio.com>loteng at lvradio.com> wrote:
Paul,
        Squeeze the two tabs on either side of the face plate and pull out.
Be careful you don't short the Circuit board to the chassis as it will
reboot the machine or worse.  I'll copy you on my logging sheet when I have
time this week.
Bill

 > -----Original Message-----
 > From: Paul B. Walker, Jr.
 >
 > Is anyone familiar with the white Burke EAS unit that has the printer in
 > the
 > left hand side of the unit, kinda like cash register tape? Mine ran out
 > of
 > paper last night and Im having a bear of a time tryin to pul lthe face
 > off
 > to replace the paper
 >
 > Also, does anyone have pre-printed EAS Logging sheets they could send me
 > a
 > copy of?  Im talking about the kind that has a section for you to fill
 > in
 > what kind of test (RWT, RMT, etc) or Watch/Warning was rec'vd along with
 > the
 > time rec'vd, time broadcast and operator on duty. I had one at one
 > station I
 > worked for...
 >
 > i hope what I'm saying makes sense, it's 3am and I'm tired lol